HandHeld Entertainment SV Series Manual do Utilizador descarregar pdf (Página 65)

Quick Check® SV Series User’s Guide 6 - 17

~LV##

Output Interface Mode

## = 00 - 99:

This command sets the output interface mode of the unit. Modes have fixed port

activation logic defined by specific applications. Some activation parameters are

programmable. Custom modes are available – contact Hand Held Products

Technical Support. Modes included in standard SV Series are described in the

"Output Interface Modes Descriptions" on page 6-30. Example: ~LV01 sets

mode 01.

~LX#

Sync Type

~LZ##

Set Number of Codes per Label (i.e., per sync period)

This command sets the exact number of codes to be read during a sync period.

## = the number of codes. For example: ~LZ02 causes a No Read condition to

be set if exactly 2 bar codes are not fully decoded during a sync interval. This

command can also be entered by scanning a bar code. See details in the ~LN##

(page 6-14) command description.

This command overrides the ~LN## command if the number of codes set does

not = 00. If ~LZ## is set to ~LZ00, the ~LN## command takes precedence.

~Lp#

Turn partials on and off at the decoder level for all symbologies.

0 Envelope sync

1 Edge sync

2 Envelope sync w/beam control - leading edge turns

on laser, trailing edge turns off laser

Note: ~LP# sets polarity for Modes 2, 19, and 20

when ~LX2 is set.

3 Edge sync w/beam control - edge turns on beam,

bar code exiting beam turns beam off

Note:

Use ~LS02 setting for sync type ~LX3.

0 Disable

1 Enable

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 119 120

Sem comentários

HandHeld Entertainment SV Series Manual do Utilizador Página 65