HandHeld Entertainment SV Series Manual do Utilizador descarregar pdf (Página 116)

A - 4 Quick Check® SV Series User’s Guide

and offset for this material and do not use any parameters that involve

reflectance measurements for failure detection for this application. See

"Calibration Hints" on page A-5.

Note: At this point the scanner is set up for the material in the application and

the ~Sc command has been used at least once to change the scanner's

setting from the initial state.

14. To finalize the settings, transmit the SV command ~Hx (lowercase x).

This will save the new settings to non-volatile memory for permanent

operation.

15. The SV unit is now ready to be programmed for any application specific

requirements using output interface modes, or other modes of

scanning operation such as ladder orientation, static codes mode, etc.

Figure 2 - Example of "Good" Scan Profile

Bar code signal

amplitude between

yellow line and

high (7 lines in

this example)

minimum of 5 lines

Bar code signal

“flat” across

bottom

1 2 ... 111 112 113 114 115 116 117 118 119 120

Sem comentários

HandHeld Entertainment SV Series Manual do Utilizador Página 116